Z-Wave Q&A

Question 1

Hi, I wonder if I can connect this strip directly to the wire? I don't see in the advertisement any explanation how can I connect this strip. I would also like to make sure this strip can work directly with Smartthings and will not require additional hub. Regards, Gal View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec MultiSensor 6

Question 2

Hello, Will the black version be available to buy in the near future? View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 3

Hello,Will the black version be available to buy in the near future? View answer

Asked 3 ´years ago | Z-Wave Plus V2 Heltun Touch Panel Switch - Five Buttons - White

Question 4

could you use this with an existing wired door bell to replace the sounder? View answer

Asked 3 ´years ago | Z-Wave Fibaro Smoke Sensor

Question 5

Will this fit in a recessor AEO_DSE010 View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Z-Pi 7

Question 6

Did it include the Rechargeable Lithium Battery in the package? View answer

Asked 3 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 7

Does anyone know if these are 100kbps devices? The original universal binary sensor was 40k View answers

Asked 3 ´years ago | Z-Wave Plus Aeotec Smart Switch 6 - UK

Question 8

Hi, anyone using it with Athom Homey ? Does it show correctly both the power and energy ? Non-USB version of the UK plug is not showing the power at all .. View answer

Asked 3 ´years ago | Z-Wave Qubino Flush Relay x 1 Plus

Question 9

Can this be configured so that when the switch is off then power is still sent to the light bulb? I have a smart light bulb and I want to be able to use this switch to send the command to turn on and off the light and also be able to turn the smart light bulb on through an app even if the switch is off. View answer

Asked 3 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 10

I have a small, simple propane fireplace with a 2 wire connection (heat only) that needs to be controlled by a battery powered thermostat. Would this work? View answer

Asked 3 ´years ago | Z-onda mais aeotec wallmote quad

Question 11

Would this be suitable to independently control multiple infrared panel heaters? I have a fibaro HC3 and would use Aeotec multi sensors to monitor temperatures. View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Z-Pi 7

Question 12

Do the Vesternet 2,4 & 8 button z wave wall controllers work with Vera Edge? View answer

Asked 3 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 13

What Z-wave frequencies does the model you are selling work on ?I'm after one that will work in Aus (919.8 MHz, 921.4 MHz) View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec MultiSensor 7

Question 14

This is a large price reduction..Does it suggest you are no longer going to stock this item EZLO ATOM V2? View answer

Asked 3 ´years ago | Aeotec Z-Stick Gen5 USB Controller (NEW Raspberry Pi 4 compatible)

Question 15

Hi,Regarding the Z-Wave Plus Aeotec Z-Stick 7, it shows “in stock soon”, what does this mean, do you happen to have more info (eta) on this? Also, I presume when I buy this product the frequency band will be comply with EU (as I am living in Holland)?Thank you in advance!Kr,Daniel View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Z-Stick 7

Question 16

Hi, Regarding the Z-Wave Plus Aeotec Z-Stick 7, it shows âin stock soonâ, what does this mean, do you happen to have more info (eta) on this? Also, I presume when I buy this product the frequency band will be comply with EU (as I am living in Holland)? Thank you in advance! Kr, Daniel View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Heavy Duty Outdoor Switch

Question 17

Will these dimmers work with Zipato Zipabox 2? View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Z-Pi 7

Question 18

Before buying this I wonder if anyone has tried the Smartthings Web driver reassignment as in this discussion:https://community.smartthings.com/t/fibaro-fgs-224-any-experience-dh/199429I see @johan has asked a similar question. I cannot find any published drivers for Smartthings other than this forcing the device assignment as double switch. View answer

Asked 3 ´years ago | Z-Wave Fibaro Double Smart Module

Question 19

Before buying this I wonder if anyone has tried the Smartthings Web driver reassignment as in this discussion: https://community.smartthings.com/t/fibaro-fgs-224-any-experience-dh/199429 I see @johan has asked a similar question. I cannot find any published drivers for Smartthings other than this forcing the device assignment as double switch. View answer

Asked 3 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 20

Hellow, is this product will work in israel with existing modules? where the zwave frequancy is 916? View answer

Asked 3 ´years ago | Z-Wave Philio 2 in 1 Temperature / Humidity Sensor - Gen5

Question 21

Hi, will this remote work with Vera so it can arm and disarm the alarm? View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Smart Switch 6 - UK

Question 22

Can't add this to Homeseer - just errors on Addnode.Also, previously with version 6 I have a poe splitter to power it.With this version it doesn't seem to work and a USB to micro usb is supplied. Presumably I need to poe split differently??? ( not entirely sure why it doesn't power ) View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec MultiSensor 7

Question 23

Should I expect the internal battery to be reporting at 60% when fresh out of the box?Does it charge overtime? View answer

Asked 3 ´years ago | Z-Wave Heatit Z-Smoke Detector - 230V

Question 24

Are these for UK or EU sockets? View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec Range Extender 7 - EU (Double Pack)

Question 25

Is this supplied with a schuko-to-UK adapter? View answer

Asked 3 ´years ago | Aeotec Range Extender 7 - EU Socket

Question 26

Does this unit work as a dimmer for a light circuit connected directly? View answer

Asked 3 ´years ago | Z-Wave Plus V2 Heltun Touch Panel Switch - One Button - White

Question 27

The marketing and product box for this item promotes that you can plug it in and power it from a nearby socket. They show this in the manual for the US 110v version , but for the UK/EU 230v version it suggests it has to be hard wired into the main consumer unit ?As I have a socket right next to the consumer unit? Please could someone explain why I can’t connect the power cable to a UK plug and power it, rather than pay for an electrician to hardwire it? View answer

Asked 3 ´years ago | Z-Wave Plus Mètre de puissance de pince Aeotec - une pince (60a)

Question 28

Sensor 6 has several flaws. Reset button link via a piece of dodgy plastic, poor light level reading, poor UV reading.Apart from these, it was very good. Have they been addressed in Sensor 7? E.G. What range is read for the light level?Can I trust the reset mechanism? Can I assume it will work well with RaZberry? View answer

Asked 3 ´years ago | Z-Wave Plus Aeotec MultiSensor 7

Question 29

Is there is voltage leakage with 3 wire setup or is it only present in 2 wire setup? View answer

Asked 3 ´years ago | Vesternet Z-Wave Regulador de fluxo luminoso

Question 30

Can this MCO MH7H-EH V2 thermostat be used to control both Electric Under Floor heating and a Towel warmer, but both independantly from each other please?If not, is there an alternative product which can do this ?Many thanks,Richard BlatchBoxford Suffolk View answer

Asked 3 ´years ago | Z-Wave Plus MCO Home Electrical Heating Thermostat with Humidity Sensor - V2

Question 31

Is there a button on the plug-switch to enable me to over-ride the light etc on/off please? View answer

Asked 3 ´years ago | Z-Wave Plus Secure Smart Plug Switch

Question 32

Are the contacts in this model 'dry'? I want to use the module to momentarily connect a separate 12VDC circuit. (Mimicking a make/break switch.)Already have many FGS211/FGS221 modules which are dry. But want to make sure there is no change of internal circuitry for this module. View answer

Asked 3 ´years ago | Z-Wave Fibaro Double Switch 2

Question 33

Hi I am unable to get the Fibaro FGS-224 Double Smart Module to work with Samsung SmartThings Hub v3. I have managed to get it to pair with the v3 hub but only as a generic multifunction device. Only one channel works as a switch. Regards Johan View answer

Asked 3 ´years ago | Z-Wave Fibaro Double Smart Module

Question 34

Which zwave dimmer modules will this work with? View answer

Asked 3 ´years ago | Vision Dimmer Bypass

Question 35

Manual says "Maximum length of wires: 3 meters". Is that really the case and does it apply for both input and output wiring? Thinking of installing these on the DIN rail with Eutonomy housings, but 3-meter cable restriction would make this impossible. View answer

Asked 4 ´years ago | Z-Wave Fibaro Double Smart Module

Question 36

Hi, is it possible to remove the logo from the front easily? View answer

Asked 4 ´years ago | Z-Wave Plus MCO Home Glass Touch Dimmer

Question 37

Hi would this be compatable with a wired ring video doorbell to allow me to open a gate remotely View answer

Asked 4 ´years ago | Z-Wave Popp Electronic Door Opener Controlmodule

Question 38

what is the z-wave frequency, i assume it is 868mhz? View answer

Asked 4 ´years ago | Z-Wave Plus Aeotec Range Extender 6 - UK Socket

Question 39

Hello, I have many facilities in different places {hundreds} and I want to manage the entry permits for different suppliers. I would be happy if you get back to me how can this be done? asaf cohen View answer

Asked 4 ´years ago | Poly-Control Extendable Security Cylinder for Danalock V3

Question 40

This says Pi4 compatible but in the supporting documentation it says "not without un-powered USB hub)". Some have said that this is the latest version of this Z-stick but according to the Aeotec site there is a later version called Aeotec Gen5+ which is compatible with a Pi4 without having to use a USB hub. Anyone able to clarify this please? View answers

Asked 4 ´years ago | Aeotec Z-Stick Gen5 USB Controller (NEW Raspberry Pi 4 compatible)

Question 41

Is it support EU frequency (868.42)? View answer

Asked 4 ´years ago | Z-Wave Plus Aeotec Trisensor

Question 42

I have several Qubino Mini Dimmer modules in my current set up - HomeSeer with Aeotec Z-Stick controller. Can I substitute one of these for the Qubino module? View answer

Asked 4 ´years ago | Vesternet Z-Wave Regulador de fluxo luminoso

Question 43

Hi, I was wondering if this would work with Economy 7 electricity, meaning does it have an internal battery to keep it on and connected to the network when economy 7 isn't active? I'm wondering if it is possible to make economy 7 storage heaters smarter. Thanks. View answer

Asked 4 ´years ago | Z-Wave Plus Aeotec Heavy Duty Outdoor Switch

Question 44

Will the switch send instant status updates back to Vera? To answer the review where this wasn't working I ended up finding the solution here https://community.ezlo.com/t/heltun-he-tps04-and-vera-lite-experience/217229

Asked 4 ´years ago | Z-Wave Plus V2 Heltun Touch Panel Switch - Four Buttons - White

Question 45

What is the length of the new Q-Reader lead between the pulse module and the data logger. I have a long distance (approximately 22m) between the meter (located next to road) and the house and propose to connect the pulse module to the requisite cores of a CAT5e cable (already laid underground) and then connect the Q-Reader within the house where it can connect via z-wave to my hub. Is this proposal possible if the cable is not long enough? View answer

Asked 4 ´years ago | Z-Wave Sähkömittareiden tiedonkeruulaite

Question 46

Is this also compatible with the Raspberry Pi 400 running Home Assistant? Or is there a suitable alternative I should look at? View answers

Asked 4 ´years ago | Aeotec Z-Stick Gen5 USB Controller (NEW Raspberry Pi 4 compatible)

Question 47

Is this the latest (2019, green) version of this board, or the slightly earlier (2018, blue) version? Obviously the photo shows a blue one, but good to know for sure! View answer

Asked 4 ´years ago | Z-Wave.me RaZberry 2 PI GPIO Daughter Card - Gen5 - New

Question 48

Is it resistant to condensation/waterproof? What is the operating humidity range? View answer

Asked 4 ´years ago | Z-Wave Fibaro Multi Sensor

Question 49

Does it include an acceleration sensor (accelerometer or any kind of vibration sensor) for door knocker detection? View answer

Asked 4 ´years ago | Z-Wave Technisat Door/Window Sensor

Question 50

Hello, I have an issue with Hubitat's z-wave range, does this device also function as a z-wave repeater? View answer

Asked 4 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Z-Wave Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools