Question 1

Hi, will two of these fit in a two gang wall box? I have both pendant and wall lights in my lounge View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 2

Use for a UK 2-wire (No neutral) switch with a 13W LED non-dimmable bulb in hallway, do I need to install with the bypass 2? View answer

Asked 8 ´years ago | Z-Wave Fibaro Universal Dimmer 2

Question 3

Will this work with the latest Aeotec Nano Dimmer for which does not have a bypass available yet? I cannot beleive that the internals will be much difference between provisors - basically some additional resistance and capacitance added. Has anyone tied this and can report compatability? View answer

Asked 8 ´years ago | Z-Wave Fibaro Dimmer Bypass 2

Question 4

Will this work with a PWM Immersion heater (ie. one that can very it's power). Other meters give false readings for me when it's on.

Asked 8 ´years ago | Z-Wave Plus Aeotec Clamp Power Meter - Three Clamps (60A)

Question 5

Can this be used as four separate 36w 12v channels? I want to control four sets of 12v led lamps but am not sure if it can only be controlled as if it were colour, so I would have to choose, for instance, yellow, to have two sets on? View answer

Asked 8 ´years ago | Brands - Qubino > Z-Wave Qubino RGBW Dimmer Plus

Question 6

Hi Vesternet team, If i add a schedule in the Z-wave controller and eg my wife add a schedule on the thermostat than what happens? View answers

Asked 8 ´years ago | Z-Wave Plus Secure 7 Day Programmable Room Thermostat

Question 7

Can you confirm that S2 can control a second lighting circuit alongside one on S1? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 8

In the US they sell a touch display that plugs directly into this module but its the wrong size for the UK. Does anyone know if they will sell a UK version? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 9

Can this module be used behind a standard UK Socket and control/monitor it? View answer

Asked 8 ´years ago | Z-Wave Fibaro Double Switch 2

Question 10

What does the physical switch attached to this device do? does it activate the dimming or does it just enable/disable the whole device? Forgive the naiivety of the question, I'm still a noob at this View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 11

Manual says it transmits every 15mins in Normal mode. But does the message contain multiple readings or only a single reading covering the entire 15mins. I am after history with lower granularity, say 1min, but don't want to drain battery with Real-Time mode.

Asked 8 ´years ago | Z-Wave Data Logger for E-Meters

Question 12

Will this work with the new smart gas meters. (EDF have installed a Flonidan branded Smart Gas Meter but it cannot connect to the mobile telephone network so cant get at the data)

Asked 8 ´years ago | Z-Wave Data Logger for E-Meters

Question 13

What's the difference between this model (FIBEFGS-223) and the FIBEFGS-222? One is described as a switch and the other as a relay, but otherwise seem identical. Does it make any difference to what it can do? I want to use them behind existing light switches to control lighting circuits - does it make any difference which I use? Thanks! View answers

Asked 8 ´years ago | Z-Wave Fibaro Double Switch 2

Question 14

How is this better than the Fibaro Dimmer 2 (which I just bought)? "outperforms all that has come before it" is quite a grand claim - is it just compatible with a broader selection of LED bulbs? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 15

Does this have Low Battery Alert? View answers

Asked 8 ´years ago | Z-Wave Fibaro Flood Sensor

Question 16

Does this work with Samsung SmartThings Hub? View answers

Asked 8 ´years ago | Z-Wave Fibaro Flood Sensor

Question 17

Which bypass do you recommend & stock, for use with lighting loads below 4 watts? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 18

Please can you recommend other night latches which are compatible with the keyless smart lock. This is the only one Yale lists as compatible but I do not like it.

Asked 8 ´years ago | Brands - Yale > Yale Smart Living Y3 Contemporary Nightlatch

Question 19

I am looking for a Z-Wave Plus LED controller that has DMX512 output. Does this device or do you know of any others that fit the bill please? View answer

Asked 8 ´years ago | Brands - Qubino > Z-Wave Qubino RGBW Dimmer Plus

Question 20

Has anybody seen an issue where the Q outputs don't follow the S inputs? I have to toggle the state of the input switch a few times to get it to sync up. The input switch is the microswitch on my Heating Control Valve. View answer

Asked 8 ´years ago | Z-Wave Fibaro Double Switch 2

Question 21

I am using a pir to switch this on which seems to work but it keeps showing as device not detected! I'm using Vera edge is there a parameter I need to change or is it not compatible thanks View answers

Asked 8 ´years ago | Z-Wave Fibaro Single Switch 2

Question 22

When will Aeotec Wallmote double be available for UK installation & quad back in stock? View answers

Asked 8 ´years ago | Z-Wave Plus Aeotec WallMote Quad

Question 23

Does this have the possibility of manual override in case Z-wave is down? I don´t see a button View answer

Asked 8 ´years ago | Qubino 32A Contactor for Smart Meter

Question 24

It says "For use with Qubino Smart Energy Meter". Is the Smart Meter a requirement to use this contactor or can it be used without it? View answers

Asked 8 ´years ago | Qubino 32A Contactor for Smart Meter

Question 25

Can this be controlled locally via SmartThings if there is no internet connection? It is possible to link a Z-Wave remote to it directly? View answers

Asked 8 ´years ago | Z-Wave Plus Aeotec Smart Switch 6 - UK

Question 26

Does this device work fully with HomeSeer? View answer

Asked 8 ´years ago | Z-Wave Fibaro Double Switch 2

Question 27

Would there be a minimum GU10 number of lights that would not need a Fibaro dimmer 2 ? I have a number of circuits with GU10 lights 6W X 9 in a kitchen and out in a hallway 2 way circuits of 2 each by 2 and a circuit of 4. Would I need a dimmer bypass then for all circuits. View answer

Asked 8 ´years ago | Z-Wave Fibaro Universal Dimmer 2

Question 28

Does anyone know if this unit is stable with HomeSeer? I have a couple of the Fibaro Dual Relay units but their status reporting is flaky at best and I cannot rely on them. - Thanks! View answer

Asked 8 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 29

Hi - when wired this into a double switch and then included this with a Vera Plus controller there were 3 devices created - the master and 2x appliance modules. In Vera only using the master switch has an affect and it only controls one of the switches. How do I include this so that both switches are controlled? View answer

Asked 8 ´years ago | Z-Wave Fibaro Double Switch 2

Question 30

I have a set of motorised curtains which run off 12V DC. Can I use this device to control them? It has a 4-wire input in addition to the 12C DC power socket: Green:Close/Open, Red:Open/Close, Yellow:Stop, Black:Neutral. View answers

Asked 8 ´years ago | Z-Wave Qubino Flush Shutter DC

Question 31

Is this compatible with Vera Edge please? View answers

Asked 8 ´years ago | Z-Wave Plus Secure SES302 Temperature Sensors Gen5

Question 32

The blurb on this product says you can connect an external probe, but one is not supplied. The picture shows a very neat looking probe. Can anyone recommend a specific (and cost effective) probe that is known to work with this sensor? View answer

Asked 8 ´years ago | Z-Wave Fibaro Flood Sensor

Question 33

Can this unit be controlled by other Z-wave controllers? Is the Smart Meter required for it to function?

Asked 8 ´years ago | Qubino 32A Contactor for Smart Meter

Question 34

Can this unit be controlled from other z-wave controllers? or is the smart meter required? View answer

Asked 8 ´years ago | Brands - Qubino > Z-Wave Qubino Smart Meter ZMNHTD1 Plus

Question 35

Does this work with 3 way switched circuits? Can't find a wiring diagram for even 2way switching in the manual. View answer

Asked 8 ´years ago | Z-Wave Fibaro Double Switch 2

Question 36

Out of stock within 3 days of email saying in stock. Pointless. Bad. How to lose customers.

Asked 8 ´years ago | Z-Wave Plus Aeotec Smart Switch 6 - UK

Question 37

How can this be set up for two-way circuits? i.e. two switches controlling one light. I can't see a wiring diagram to support this in the manual. View answers

Asked 8 ´years ago | Z-Wave Fibaro Double Switch 2

Question 38

My door is 76mm wide, do you have an extension kit for this lock? View answer

Asked 8 ´years ago | Yale Conexis L1 Smart Door Lock - Polished Chrome

Question 39

is this a straight swap for the existing Yale Smart living Keyfree multipoint lock? View answer

Asked 8 ´years ago | Yale Conexis L1 Smart Door Lock - Polished Chrome

Question 40

Does this have an outdoor IP rating? If so please could you let me know what it is?

Asked 8 ´years ago | Z-Wave Popp Electronic Door Opener Controlmodule with Door Opener

Question 41

Does anyone know if there is a zwave module for this lock? View answers

Asked 8 ´years ago | Yale Conexis L1 Smart Door Lock - Polished Chrome

Question 42

What is the average battery life in this button, how often does it need to be replaced or recharged? View answer

Asked 8 ´years ago | Z-Wave Philio Smart Colour Button Gen5

Question 43

For Vera is changing the device type to scene controller a guaranteed way to get the single button press to work every time? View answers

Asked 9 ´years ago | Z-Wave Fibaro Button

Question 44

Does Z-Wave Aeon Labs Clamp Power Meter Gen5 - One Clamp (60A) sense current direction, ie import or export of power? View answers

Asked 9 ´years ago | Z-Wave Plus Aeotec Clamp Power Meter - One Clamp (60A)

Question 45

Is this compatible with Home Assistant?

Asked 9 ´years ago | Z-Wave Fibaro Button

Question 46

does it detect carbon monoxide? View answers

Asked 9 ´years ago | Z-Wave Fibaro Smoke Sensor

Question 47

Will this sensor work with an Aeotec Z-Stick V2 (Version: 1.4-2228-gbce4a88-dirty)?

Asked 9 ´years ago | Z-Wave Plus Aeotec MultiSensor 6

Question 48

Is it compatible with Nanoleaf smart light bulbs? View answer

Asked 9 ´years ago | Z-Wave Philio Smart Colour Button Gen5

Question 49

Will the Z-Wave.me USB stick run on a Synology NAS using Domoticz/OpenZWave? i.e. through a Linux OS? I understand OpenZWave is fine but not sure on the OS aspect... View answers

Asked 9 ´years ago | Z-Wave.Me USB Stick

Question 50

Does this use the European or USA Z-wave frequency? View answer

Asked 9 ´years ago | Z-Wave Plus Secure Wall Switch

Browse by Topic

Tools