Z-Wave Zooz Universal Relay

Dual Z-Wave Outputs

Convert almost any 0–240 V load into a Z-Wave device—perfect for garage doors, pumps, DC motors, HVAC systems, and more. Each output supports normally open (NO) or normally closed (NC) relay configurations, handling up to 20 A on NO and 10 A on NC.

Control up to 2 connected loads independently or together using dry contact relays. Power the device via 12–24 V AC/DC or USB-C (adapter not included). Built-in timers simplify automation, and the Z-Wave Plus repeater helps extend network range. Follow the manual or contact support for wiring guidance tailored to your installation.

Smart Monitoring Inputs

Monitor analog sensors, dry contacts, or low-voltage devices using the Universal Relay inputs. Each output can be triggered via wall switches, buttons, or signals from HVAC and alarm systems.

Note: each output accepts only one input type at a time—either 12–24 V AC/DC or dry contact. Inputs can also operate independently for monitoring purposes.

Customise reporting through your Z-Wave controller for motion, open/close, water detection, or on/off status, turning the relay into a smart monitoring solution with two independently controlled outputs.

Automate Two Garage Doors with One Universal Relay

Connect a wired door sensor to monitor open/close status through your Z-Wave controller, and wire the relay to your opener for remote control. You can also use a Z-Wave tilt or contact sensor for position updates.

Note: Each output supports only one input type at a time—either 12–24 V AC/DC or dry contact. Use with compatible Z-Wave controllers only.

\

Ways to Use the Universal Relay

Automate up to two garage doors by connecting a wired sensor for open/close monitoring and wiring the relay to trigger the opener remotely. Each output operates independently, supporting normally open (NO) or normally closed (NC) relays with loads up to 20 A (NO) or 10 A (NC).

Perfect for controlling DC motors, pumps, shades, screens, or awnings. Also ideal for optimizing HVAC systems with automated dampers or whole-house fans. Power via 12–24 V AC/DC or USB‑C. Built-in timers and Z-Wave Plus repeater extend automation capabilities and network range.

ETL Certified with Advanced Z-Wave Features

The Universal Relay is ETL-certified for safety compliance and designed to operate reliably within Z-Wave networks. It supports Z-Wave S2 security and SmartStart for secure, hassle-free inclusion, and acts as a Z-Wave Plus repeater to extend network range. Over-the-air firmware updates keep your device future-ready. Covered by a 1-year limited warranty, with an extended 5-year warranty when registered, plus dedicated tech support.