Vesternet Z-Wave 2 Channel Switch - Technical Support - Hubitat

The VES-ZW-SWI-014 is a Z-Wave 2 Channel Switch and offers the following features:

  • 3-Wire (with Neutral) wiring
  • 2 Output Channels
  • 2 Switch Input Channels
  • Supports Momentary Switches
  • Supports Scene Commands For Switch Inputs
  • 5.1A Resistive Load (1.7A Capacitive / Inductive Load) per channel
  • Power, Energy, Voltage & Current Metering (whole device only)
  • Small Installation Size 45.5 x 45 x 20.3 mm
  • Power Failure Load State Remembering
  • Z-Wave Plus  v2 700 Series with S2 Security

 

A manual for this device can be downloaded here.

Vesternet Z-Wave Device Drivers

These can be downloaded from here.

Two files are required for this particular Device:

  • VES-ZW-SWI-014 2 Channel Switch.groovy
  • VES-ZW-SWI-014 2 Channel Switch Child Switch.groovy

 

Please report any issues with the Vesternet Z-Wave Device Drivers by submitting a technical request ticket.

This Vesternet Z-Wave Device has the following features when used with our supporting Device Driver in the Hubitat Smart Home Controller (tested with Hubitat firmware version 2.2.6.139).

  • Supports On and Off Control of each channelfrom the Web UI.
  • Reports On and Off Events for each channel when operated from the local switches.
  • Reports Power, Energy, Current and Voltage Meters for the whole device.
  • Can be used as a "Trigger" for On and Off Events for each channel in built-in Apps such as Basic Rule, Simple Automation Rules and Rule Machine.
  • Can be used as a "Trigger" for Meter Events for the whole device in built-in Apps such as Basic Rule, Simple Automation Rules and Rule Machine.
  • Can be used as an "Action" for On and Off Control of each channel in built-in Apps such as Basic Rule, Simple Automation Rules and Rule Machine.
  • Has configuration options for Meter reporting and the default load state after power failure.