SmartThings Compatible Q&A

Question 1

Does this work with the Yale YMF 40 Mortise Lock?

Asked 7 ´years ago | Yale Smart Living Z-Wave Module 2

Question 2

Has anyone got this (Yale Smart Living Z-Wave Module 2) to work with the Zipato Zipabox?

Asked 7 ´years ago | Yale Smart Living Z-Wave Module 2

Question 3

What's the difference between this and the first version? View answers

Asked 7 ´years ago | Yale Smart Living Z-Wave Module 2

Question 4

Hello, Can this touch Panel control shutters or blinds? Thank you View answer

Asked 7 ´years ago | SmartThings Compatible > Z-Wave Plus MCO Touch Panel Switch - Two Load - UK

Question 5

Hi, Can this switch fix on the UK standard backbox 35mm depth? https://www.screwfix.com/p/appleby-1-gang-35mm-dry-lining-box/44827 If not, what backbox should I use? Also, what is the difference between this Gen5 and the other similar priced non-Gen5 switch? Thank you in advanced. Joe. View answer

Asked 7 ´years ago | Z-Wave Plus MCO Touch Panel Switch - Four Load - UK

Question 6

I'm about to pull the trigger on the Conexis L1 and Z-Wave Module 2 for my Fibaro HC2 but I'm hearing lots of reports of the module draining the 4 AA batteries in the Conexis L1 lock, like Malath A mentioned in the review section of this product on Vesternet Does anyone have more insight into this? Thanks Andy

Asked 7 ´years ago | Yale Smart Living Z-Wave Module 2

Question 7

Are they shipping with v1.11 firmware? Short of buying a usb device too there is no way to upgrade via smartthings. View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec MultiSensor 6

Question 8

The description states that this requires a neutral wire, however the single output version of this module does not; so is that correct in the description? View answer

Asked 7 ´years ago | Z-Wave Plus AEOTEC Dual Nano przełącznik z pomiaru mocy

Question 9

Does this module work with Fibaro? View answers

Asked 7 ´years ago | Yale Smart Living Z-Wave Module 2

Question 10

is this z-wave plus ?? View answer

Asked 7 ´years ago | Yale Smart Living Z-Wave Module 2

Question 11

Hi does this product support 2 way switch as well or only 2 single switches? View answer

Asked 7 ´years ago | Z-Wave Plus AEOTEC Dual Nano przełącznik z pomiaru mocy

Question 12

Will this control two light circuits? View answer

Asked 7 ´years ago | Z-Wave TKB Dual Paddle Wall Dimmer TZ35D - Gen5

Question 13

I have a fused Switch controlling a fan and want to use this controller to operate the fan remotely as well as enabling the fused switch to continue controlling the fan at the wall, is there a wiring diagram showing how to achieve this? View answers

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Switch On/Off Controller

Question 14

If I want to change batteries after installation, the whole housing will shoot up in to the insulation since theres no retention ring holding back the housing when I take the sensor out. It makes it near impossible to change batteries unless I'm able to get to the sensor from the backside. How do I do this?

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 with Round Recessor - Gen5

Question 15

Is this dimmer switch suitable for LED bulbs? That is, is it a trailing edge dimmer? View answer

Asked 7 ´years ago | Z-Wave TKB Dual Paddle Wall Dimmer TZ35D - Gen5

Question 16

Does the Aeotec Nano work with 3-Position Momentary Switch - S1, On and Up - S2 Off and Down View answers

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 17

Does this require 3-wire installation system (neutral)? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Switch On/Off Controller with Power Metering

Question 18

Where is the Aeotec bypass? Aeotec's website still says that it will be available "early 2017", and yet here we are here in September and I cannot see much evidence of its availability. Does anyone have any insights into when it will be available? Thanks. View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 19

Is it possible to use these to control a 240v relay without chatter? We tried this by altering parameters 11,12 and 15 but were not successful. Any advice appreciated. View answer

Asked 7 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 20

Hey, will it work with the Vera Plus?

Asked 7 ´years ago | Z-Wave Philio 2 * 1.5 KW Relay Inserts

Question 21

Is the common connection a 3v output like the micro modules?

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 22

When controlled by the local switch, can the level be controlled e.g. press briefly to turn on/off, press and hold to cycle the brightness? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 23

Is this Controller working with vera plus? View answer

Asked 7 ´years ago | Z-Wave Qubino Flush Shutter Plus

Question 24

hello does anyone know if there is a template for the fibaro hc2 so it will work properly. thanks

Asked 7 ´years ago | Z-Wave Philio 2 in 1 Temperature / Humidity Sensor - Gen5

Question 25

Why do these show as requiring a fuse whereas other like the Fibaro do not show this as a requirement in the wiring diagrams? View answer

Asked 7 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 26

Does this work with Vera, if so can you also control the colour LED? View answer

Asked 7 ´years ago | Z-Wave Philio Smart Colour Button Gen5

Question 27

I read the following in the manual: Rated output power 8A for single output channel,13A at max.(3,25A for R.G.B.W. single output channel is suggested) I'm planing to control two strips of LED with the RGBW-Dimmer. Using two of the four channels. How much power (current) can each of the two LED-strips have? (I'm using a 24V driver). Maybe 13A/2 = 6.5A per channel? View answer

Asked 7 ´years ago | Z-Wave Qubino RGBW Dimmer Plus

Question 28

Is this 2 wire compatible. i.e. Does it require a neutral? View answer

Asked 7 ´years ago | Z-Wave TKB Dual Paddle Wall Switch TZ36D - Gen5

Question 29

Can this be connected to two bell-push switches, to activate two lighting scenes? The lights would be powered by other zwave modules (dimmers), so these would purely be used to trigger the scenes. View answer

Asked 7 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 30

hi is this light dependent . ie only work at night ? also does it work with n-cube controller?

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 - Gen5

Question 31

Hi, I had successfully setup 1x MultiSensor 6 (ZW100-C) which required a change of device type. I then purchased 2 more (same model, same firmware) but they have aren't detecting any motion. Is there any advice on how to resolve this? I have tried a number of different DTH, removing and repairing etc and now looking for some help.

Asked 7 ´years ago | Z-Wave Plus Aeotec MultiSensor 6

Question 32

Are there any special instructions for including this in a Vera Edge system. It seemed to install but will only notify about tampering and has no apparent reaction to movement other than a small fashing led. No notifications.

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 - Gen5

Question 33

how do these perform with metal back boxes? Is there a significant reduction in effectiveness / range? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 34

Is it possible to change colors of the light bulb using smartthings View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 35

If I mount this in a roof, what's the max angle that it can be moved to in the horizontal & what's the andle of detection?

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 with Round Recessor - Gen5

Question 36

hello, does anyone know if this can be used with a fibaro hc2 and does it do anything else like lux, temp or humidity. thanks View answers

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 - Gen5

Question 37

Hi. What wireless switch could I use with this dimmer? And do I need a 3rd party device (e.g. Vera or Smartthings) to configure them to talk to each other? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 38

Hi, will two of these fit in a two gang wall box? I have both pendant and wall lights in my lounge View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 39

Can this be used as four separate 36w 12v channels? I want to control four sets of 12v led lamps but am not sure if it can only be controlled as if it were colour, so I would have to choose, for instance, yellow, to have two sets on? View answer

Asked 8 ´years ago | Z-Wave Qubino RGBW Dimmer Plus

Question 40

Can you confirm that S2 can control a second lighting circuit alongside one on S1? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 41

In the US they sell a touch display that plugs directly into this module but its the wrong size for the UK. Does anyone know if they will sell a UK version? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 42

What does the physical switch attached to this device do? does it activate the dimming or does it just enable/disable the whole device? Forgive the naiivety of the question, I'm still a noob at this View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 43

How is this better than the Fibaro Dimmer 2 (which I just bought)? "outperforms all that has come before it" is quite a grand claim - is it just compatible with a broader selection of LED bulbs? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 44

Which bypass do you recommend & stock, for use with lighting loads below 4 watts? View answer

Asked 8 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 45

I am looking for a Z-Wave Plus LED controller that has DMX512 output. Does this device or do you know of any others that fit the bill please? View answer

Asked 8 ´years ago | Z-Wave Qubino RGBW Dimmer Plus

Question 46

Does anyone know if this unit is stable with HomeSeer? I have a couple of the Fibaro Dual Relay units but their status reporting is flaky at best and I cannot rely on them. - Thanks! View answer

Asked 8 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 47

My door is 76mm wide, do you have an extension kit for this lock? View answer

Asked 8 ´years ago | Yale Conexis L1 Smart Door Lock - Polished Chrome

Question 48

is this a straight swap for the existing Yale Smart living Keyfree multipoint lock? View answer

Asked 8 ´years ago | Yale Conexis L1 Smart Door Lock - Polished Chrome

Question 49

Does this have an outdoor IP rating? If so please could you let me know what it is?

Asked 8 ´years ago | Z-WAVE POPP Elektroninen ovi avaaja ControlModule kanssa Oven avaaja

Question 50

Does anyone know if there is a zwave module for this lock? View answers

Asked 8 ´years ago | Yale Conexis L1 Smart Door Lock - Polished Chrome

SmartThings Compatible Q&A

Activity timeframe

Browse by Category

Browse by Category

Browse by Topic

Tools