The VES-ZW-MOT-018 is a Z-Wave Motor Controller and offers the following features:
- 3-Wire (with Neutral) wiring
- 2 Output Channels
- 2 Switch Input Channels
- Supports Momentary Switches
- 2A Capacitive / Inductive Load per channel
- Works with positioning to allow Precise Control
- Automatic Calibration
- Power, Energy, Voltage & Current Metering
- Small Installation Size 45.5 x 45 x 20.3 mm
- Z-Wave Plus v2 700 Series with S2 Security
A manual for this device can be downloaded here.
Vesternet Z-Wave Device Drivers
These can be downloaded from here.
One file is required for this particular Device:
- Vesternet VES-ZW-MOT-018 Motor Controller.groovy
Please report any issues with the Vesternet Z-Wave Device Drivers by submitting a technical request ticket.
This Vesternet Z-Wave Device has the following features when used with our supporting Device Driver in the Hubitat Smart Home Controller (tested with Hubitat firmware version 2.2.6.139).
- Supports Open and Close from the Web UI.
- Reports Open and Close Events for each channel when operated from the local switches.
- Reports Power, Energy, Current and Voltage Meters for the whole device.
- Can be used as a "Trigger" for Open and Close Events in built-in Apps such as Basic Rule, Simple Automation Rules and Rule Machine.
- Can be used as a "Trigger" for Meter Events for the whole device in built-in Apps such as Basic Rule, Simple Automation Rules and Rule Machine.
- Can be used as an "Action" for Open and Close Control in built-in Apps such as Basic Rule, Simple Automation Rules and Rule Machine.
